Detroit Axle - Front 4pc Control Arms for 1999-2004 Jeep Grand Cherokee | 1999 2000 2001 2002 2003 2004, 4 Upper & Lower Control Arms Assembly Set Replacement

fit just fine no problem with them . so far happy with my choice

Part was of good quality and had everything needed to complete the job. Fit up was good and the alignment shop was able to align the car.

Durable, High-Quality Control Arms – Perfect Fit! ⭐⭐⭐⭐⭐ I recently replaced my old control arms with these, and I couldn’t be happier! The build quality is solid, with heavy-duty materials that feel just as good (if not better) than OEM parts. Installation was straightforward, and they fit perfectly with no modifications needed. After installing them, I immediately noticed a smoother ride and improved handling. No more clunking or instability—my car feels like new again! If you’re looking for reliable and well-made control arms at a great price, these are definitely worth it. Highly recommend!

Loved that I could buy the whole front set, with the bushings already installed, for about the same price as just buying new bushings alone. They fit great, with one exception. My 2001 4WD Grand Cherokee had a metal clip installed on the drivers side lower arm, that holds the front diff vent tube away from rubbing on the driveshaft. The hole for that clip was not there on the new arms (see pic, that hole was there on both of the original arms). I drilled a new hole and installed the clip. Everything else went quite smoothly. Overall, they seem to be great. I'd like to rate them 4.75, but that's not an option. ;-) It would be near perfect if the kit came with those 2 bushings that are pressed into brackets on the axle housing. Without replacing those, the job is only 75% complete. :-( Be sure that you tighten the bolts to spec, but don't tighten them until the suspension is supporting the full weight of the rig. If you tighten them while the suspension is hanging down, then the bushings will be getting twisted too much when the suspension is compressed, resulting in a greatly shortened lifespan. The lower ones have to be TIGHT, 115 ft/lb for the frame end and 120 ft/lb for the axle end. Tough do do while the rig is sitting on the ground. The upper bolts are much smaller and only have to be torqued to 45 ft/lb each.

Perfect factory replacement

These look, fit and feel as good as OEM. Would buy from them again.

A

good product good price

Seem to be great quality and fit great.

This was an excellent find, way more convenient that buying seperate balljoints and wrestling with rusted parts. I left it to the garage for the install, a .7/per side cost and it made the alignment a breeze. It was a very reasonable price, which was a relief. With prices of everything nowadays going through the roof, it was a nice change. Would buy again!

Perfect fit on my 2003 f150

Terrible , not even the dans specs as the OEM ..they don't fit properly on a 2009 Ford Focus. They dammaged my car ans pour my Life at risk by making the car unsafe. My mechanic told me to "Stay Away from this crap " . I had to Return them.

Very well-made