SuPoo for Mazda Black Sporty Metal Evil 'M' Rear Trunk Badge Decal Emblem Glossy 3 5 6

Nice emblem worked as it should and easy to install. Fit well on the hatch.

Encajo super bien , en mi mazda 6 y es de muy buena calidad

Great price for a strong metal emblem with a quality finish.It however does not fit the curvature of the car at all. Bending to fit perfectly is near impossible as you need to take great care not to mar the finish and placing in a vice is a necessity. Bending to fit left to right is very easy. Bending from top to bottom is not. The emblem has vertical cannels for strength reinforcement so the center area will not bend. It leaves a gap from the center down to 1/4" from the bottom tips using a vice, channel locks and a rubber mallet.I was able to get the entire top half and the very bottom 1/4" to adhere well. The gap is small but noticeable if you're close. I'm not too confident it will stay long term but it will probably be fine if avoiding automatic washes.I do a great deal of metal fabrication and bending so I'm not new to it... I'm sure it's possible to get it bent perfectly but you'll have a high chance of breaking the cast metal or deforming it beyond repair. Using a torch would definitely work but at that point you'll need to rpaint it and might as well just modify a stock emblem instead.

Perfect for my 2015 Mazda 6, The only flaw I noticed was a tiny chunk in the paint but was not noticeable from far away. Be aware these are not curved for your car so you may want to bend it a little before you remove the adhesive strip.

the logo itself is great. nice black painted metal, good quality. however the stupid adhesive it comes with is absolutely terrible. no matter what prepping and heating I did, It simply would not stick to the logo itself whatsoever.

It can sort of fit on a Gen 2 Mazdaspeed 3 but once it's formed to fit the curvature (which is no easy feat), it's just shy of fitting and the holes that the pegs on the OEM emblem go into are exposed.

Despite the 4 out of 5 stars overall and reviews, I give this a 5. Very happy with what I received. Had to manually bend at the center axis, very lightly, and also the horns that face the ground. VERY LIGHTLY. Just enough to make the curve. This is made from steel not aluminum. Take your time. Absolutely worth 10 bucks. The two faced tape was die cut very well, I would give the tape a 4 out of 5. Heat it up a little with a hair dryer.

Everyone complains of double sided tape, but it was perfect on the one I ordered, no tape hangs out, no trimming