Titan Attachments48in Bucket 23TF Tooth Bar, Universal Size Skid Steer Tractor, USA Made from United Attachments

I love it. It helps in digging up hard dirt

This is not for the small BX Kubota 23 series. My bucket is a healthy 46 inches wide on the inside. The Titan Tooth Bar is a healthy 48". I am not going to send it back. For the money, it is worth just cutting it down to fit. But I do recommend searching brands for one that actually fits 46 in. buckets.Just an update. I ended up cutting this down to fit. I cut a section out of the middle. It welded up nice. Mine also had a crooked tooth. I cut that out, reset it, welded it back in.The teeth are very aggressive and a must have for any subcompact tractor.

Surprised at the heft of this implement. "Robust" would be applicable, were that term not such a cliche. Thick metal with substantial welds all around. More surprised because it cost only $125, with free shipping. If the metal and welds hold up (no reason to suspect they will not) this can do some serious digging, grading, and loading (all of which take practice). It's spec'ed for a 47 3/4" ID bucket width, but by the thickness of the proverbial pubic hair did not slide into my Massey DL95. A few minutes with a 9" grinder applied to the ends of the bar fixed that. It wedges on the bucket blade and is held on by 4 3/4" bolts, with washers and Nylocks (provided). Since the bucket sides need to be drilled, I considered 2 sufficient. Keep the bolts slathered in anti-seize lube and it should be as removable as a clamp-on unit. CONS: This is heavy and unweildly, so have a helper assist with assembly to avoid major metatarsal damage: the weight and forward moment also subtract substantially from the loader payload, so if that is a problem consider a lighter tool, such as a Pithanna bar.

Good tooth bar for the money. Definitely not a product that was put together/welded together with care, but still a good value for the money. I had to cut a chunk of the bar out and weld it back together to make it work on a 46.5” bucket. It does the trick though. Packaging was pretty atrocious though. Showed up missing some of the nuts, bolts and washers so I had to procure my own.

Heavy duty tooth bar but it did not fit a John Deere 48" inch bucket. John Deere 1025R has bucket measurement of 49 inches and the bar is about 2 inches to short. Debating on returning or installing a 1 inch spacer on each side. The bar also came bent so it did not slide easily over the bucket edge and it will require forcing it in place but might be a challenge to remove. Good quality bar but I sure hoped it would have fit just right.

The Titan spec states that it is 47 1/4 inch long. Since my bucket is 47 1/2 inch wide I figured on needing a few spacers to fill the gap. Unfortunately, the Titan Tooth Bar is 47 3/4 inch. I had to plasma cut and grind for several hours and oxy-propane torch the mounting wings red hot to bend them before it would slide into my bucket. If it's length was as specified, there wouldn't have been a problem! I gave it 2 stars because their welds appear to be good and it had a nice paint job.

I put this in the loader of a little MF tractor fits good and easy to install. Definitely more that the little tractor can operate well. It would be better on heavier tractor with a bit more power. The Massey is a 1210 mini and has only about 17 hp and weighs in at 2000 lbs

The item is too short for the bucket have gap about 2 in. on each side of the bucket.