YHTAUTO Pocket Style Fender Flares w/Hardware Kit Fit 2004-2008 Ford F-150(Not Fit Heritage Models), 2006-2008 Lincoln Mark LT, Styleside Bed, Paintable Wheel Flare Cover Protector

We got these for my son’s first truck. He just turned 16 and he installed them with very little help from my husband. Took him an hour and a half to install.

No tsturdy at all. Not the same as the OEM ones. Does require holes to be drilled in to your truck.

The media could not be loaded.  I didn't use the large clips at all. The instructions were a lil off but I still got them on. Tips for the installation would be put the rubber on the fenders 1st. Then then the silver screws on the fenders. There's only 2 small s clips with short black screws use them for the back fenders at the up most top of the fender well.

I literally never write reviews but hopefully this info will help some people in the future. I ordered the OE style as I want some matte black pieces to offset all the chrome in my new truck.First these were significantly less expensive than all the US truck aftermarket parts companies. Yet they seem to look very similar in size and appearance.Most important tip: when putting the rubber gasket seal on the flares leave the red tape cover on and then as you push it on peel the red tape cover off every 9 inches or so. The first two flares I peeled the tape cover off before I put it on the plastic and it was a total pain. Once I tried the new way I got the rubber on the two rear flares in literally three minutes while the front two took 45 min each.Second tip: loosely secure one of the screws at each end as the first step. This makes it so much easier to then locate the other holes and feed the screws into the clips. Even the clips you have to add you can slide them around behind the flare to get them lined up. No reason to mark them first with a grease pencil like the instructions say since the black rubber squares that protect the paint from the new clips doesn’t stick anyway. So put the black square on then the clip close to the right spot then hold the flare tight to the fender and move the clip around behind the flare until you get the holes lined up.When you are first securing any/all of the screws and bolts leave them all secured just enough to not pull out. Then once they are all loosely started push the flare tight to the fender with one hand and tighten the bolt/screw tightly with the other hand.If you removed factory mud flaps like I did hopefully you saved the bolts and clips as this kit assumes you have those bolts and clips and does not have extras.I have no idea what the white plastic trim tool is for at the end of the installations steps. If you secure the rubber gasket with the long edge on the inside of the flare it’s barely visible on the outside and actually looks nice. See zoomed in pic above with the red arrow pointing to the gasket.I would say if you’re looking for an inexpensive set of relatively small, matte black fender flares this is a good option. Good luck!

Came with no instructions or hardware in the box!!! Couldn't install returned them right away.

Good quality product and easy install

No instructions or parts included

I bought these because they said they fit a 2022 F150. When I got them, nothing lined up. Sent back for a refund.