FLASHFORGE Silk PLA Filament 1.75mm Gold to Red Gradient, 3D Printer Filament 1kg (2.2lbs) Spool, Smooth and Silky Texture 3D Printing Filament, Dimensional Accuracy +/- 0.02mm

No problems. Bed adhesion was actually a little to good. I typically use a brim and I had to scrape the brim off rather than just peel off. The print came off with no problems. Printed on Bambulab P1S.

I have several different flame type filaments and they all look good.This is honestly no different than the other filaments that I have that look similar.I set up the generic PLA profile on my MK3s and print away............ no problems.Zero issues with bed adhesion and not very stringy if any... like typical silk filaments it's a little more weaker/brittle... so don't use this for actual structural parts.

Unlike other silk filaments, these are not brittle at all. They have a nice shine. I think the red/orange color transitions very well. The colors match. There are no sudden color changes. The print comes out very strong and not brittle at all. You really need some metal pliers to break the prints. I designed a large basket and printed it out on my x1 carbon. The print took 6 hours. The basket took up the entire plate. The print job went smoothly. Adhesion was excellent. There was no wrapping on the bottom even though I had a large surface area. I bend the flexible plate and the print just pops right out. The color is very vibrant, especially since it is also shiny. It will grab someone's attention when they enter the room. The transition is very smooth. It is not holographic, meaning colors won't change when looking at it from a different angle, but I do like the layer transition especially when the colors match.