Burnaway

Prints great high detail no stick or distortion issues. Best part is complete burn out and casting in under 5 hours.

Har to make casting using a plasticast and 12 hrs burnout

Considering they have given this stuff to 3 different youtube channels..2 of which had casting issues and the third posted finished castings that werent even off of the same tree they sprued when using this resin. I contacted the company after horrible print results and comparing the prints to siraya castable and apply lab works cyan castable (see pics). I sent pics of the prints and asked them what I needed to do to get better results. Never got a reply. Attempted to cast some prints with this resin ..and as a test I put them in the same flask as a couple other castable resins I use. Horrible porosity and honestly the worst results of the entire flask. So basically the two things that are supposed to be great about this resin are bs..it is NOT easy to print with, its weak and not dimensionally accurate in any way. Even with a full burnout cycle there was leftover ash..so their "rapid burnout" is wishful thinking on their part. After getting no reponse via their technical support email (besides an immediate auto-response claiming they are "on it") I am returning the bottle of resin..this stuff is way too expensive and complete junk.

So I am relatively new to this whole casting thing so take my obeservations with a grain of salt... but I do have over 20 years experience with SLA and FDM 3D printing. From that point of view, this resin works really well for tight details. I had no issues with build plate lifting or FEP capture. From a quality point of view this is a really nice Resin. My casting skills are sub par at best but the test runs I have tried thus far all seem to do what I think this should do, which is basically melt away for the replacement of the metal poured. I didn't see any residue or anything that made it seem like it would interfere. I had one area that didn't work but that was due to my lack of experience / understanding on how to properly make a sand mold and not the fault of the resin at all. If you are a hobbiest or make jewelry this seems like it would be a great addition to have in your arsenal of tools.

A total waste of money, time and energy. I follow the exact stages and procedure as instructed on monocure3d site. I used plasticast and new silver. The results are horrific!!! every cavity filled with metal, the metal looks also textured instead of smooth.

This arrived in perfect condition and looks exactly like the images. The product is exactly as described and so far I've run into no issues. It has performed as expected.

Haven't been able to set up casting yet, but the prints so far have been perfect. Looking forward to the tests of casting, and will update the review after.