Spigen GlasTR EZ FIT Tempered Glass Screen Protector for Galaxy Z Fold 6

Easy Installation and Excellent Performance I purchased this screen protector for my Samsung Galaxy Z Fold 6, and I couldn't be happier with it. The installation process was incredibly simple and stress-free, which is one of the most important factors for me when choosing a screen protector. I would never attempt to replace the protective film on the folding inner screen myself, as that's something I believe should be handled by Samsung. However, the outer screen doesn't come with glass protection, so I wanted a reliable screen protector that was easy to install, offered good protection, and maintained touch sensitivity. This product met all three of those requirements. The touchscreen remains highly responsive for both tapping and swiping, and the protector fits my phone perfectly. I've seen some reviews claiming it doesn't cover the screen completely, but that was not my experience at all. I would definitely recommend this product and would gladly purchase it again.

Great screen protector for the cover! I still have the same cover screen protector for 2 years, scratches are minimal, no bubbles, easy to apply, fits very well even with a case.

Easy to install after looking at it for a minute. To those having issues: 1. Clean the screen with the cleaning wipe 2. Use the cleaning cloth to wipe down the face of the phone 3. Make sure the orange and black pull tab is positioned properly in the alignment tool (it goes under the little tabs at the bottom of the tool) 4. Place the alignment tool over your phone so it almost clicks in place 5. Pull the orange and black pull tab straight back away from the alignment tool, it will see to catch near the end, keep pulling until fully removed 6. Swipe your finger down the center of the tool to stick the screen protector to the phone 7. Unclip the clear plastic tabs at the top and bottom from the alignment tool and remove the alignment tool from your phone 8. Taking the top, or bottom, plastic tab and peel it at an angle across the phone so that it pulls the plastic away that's protecting the top of the screen protector 9. Use the tool that came with the kit to squeeze out any bubbles from the screen protector To those stating there is a 2mm gap between the screen protector and the edge of the glass, yes there is. This is a case compatible screen protector. The entire viewing area of the screen is covered while still allowing a case to position on the phone properly, no matter how thin it is considering how most fold 7 cases work that are out right now which protect the front screen portion of the phone. In my opinion this screen protector is far superior to the Samsung one. It doesn't have an edge that catches my finger while being nice and thick to protect the screen. The face camera works great still as well as responsiveness to touch input. It holds very well to the phone screen without lifting at any edges. Overall considering the cost of the 2 pack, this was a great value. This is the first time I didnt need to use both screen protectors during install and actually have a spare one if this wears out.

I rarely leave reviews, but after spending a frustrating amount of money and wasting two full installation attempts, I’m beyond fed up with the Spigen GlasTR EZ FIT Pro Screen Protector for the Galaxy Z Fold 8 Ultra. Let me be painfully clear: this product absolutely failed to do the one basic thing a screen protector is supposed to do — sit flat on the screen. Both protectors, straight out of the box, had corners that refused to adhere to the front display of my brand‑new Fold 8 Ultra. Not a tiny bubble, not a small edge lift — I’m talking about stubborn corners that stuck up no matter how carefully or slowly I followed Spigen’s process. The alignment tray, the “EZ FIT” gimmick, the dust removal steps… none of it mattered. The corners just would not stay down. For something marketed as “premium,” this felt anything but. When you pay top dollar for a screen protector — especially one meant for a delicate device like the Fold — you expect precision, reliability, and at the bare minimum, basic adhesion. Instead, I ended up with two unusable protectors and the annoyance of peeling them off my expensive new phone because they looked awful. It’s incredibly disappointing. I trusted Spigen’s reputation, and this product fell flat — literally. Save your money and your sanity. This screen protector is nothing but a frustrating, overpriced letdown for the Fold 8 Ultra.

Easy to apply, covers useable screen but doesnt extend the full way. Its fine if you have a case but youll notice it when you try to use gestures to navigate (going back from anywhere). Overall good

Great! 5 stars! Easy installation and even then comes with an extra. I'm usually pretty bad at setting up screen protectors but the instructions are as clear as the protector itself. 0 bubbles, works great with Spigen cases as well, of course. Highly recommend!

Just got these for the Fold 8. They are smaller than the screen, so I'm disappointed. Many cases for this phone are back-only, so I don't need it smaller to be case-friendly. Other than that, great quality. Application was perfect, and I'm naturally bad at this task. Review below is from the Flip 7 version, which I liked a lot better because it covered the entire glass. The great thing about these is that they are very nearly the exact size of the cover screen of the Flip 7, so you can hardly see it at all. I'm always annoyed when the screen protector is smaller and you can see it. All of the materials in the package are high quality, so you feel like the extra cost of these is worth something - even the wet wipe is better than in other screen protectors I've purchased. The installation process was easy and straightforward. However, there is a pretty big bubble around one of the lenses and between the lenses. The squeegee is difficult to fit in between the lenses, so I've also been trying with a credit card, but I can't get it out. It's not noticeable enough to waste it and use the second protector in the package. The glass feels great and no different than the original screen.

I enjoy these screen protectors that come with an install tool. Makes it easy. + Aligned properly with no air bubbles. + Got it right the first time. - Fingerprints smudge easily. - Made smaller to fit the Spigen cases, but leaves room for dust to collect between the case edge and the protector edge.

Très bien

Perfect fit, lasts really long and best part is , it gives a new look for months. Smudge free. Love it. Felt it was slightly expensive but quality is very superior . The cheaper alternatives dont come anywhere close to this product. Buy this once and youre literally covered till you want to upgrade your handset altogether.

Fácil de usar y con instrucciones claras que permiten colocar muy fácil y rápido la carcasa

Never disappointing. Great quality and easy to fix. The only thing is very expensive, but worth the money

Easy and fits perfectly