KCH10 Magnetic and Hanger Strap Use for Multimeter Meter Hanging Hang Kit

Awesome, strong magnet and very easy to use!

Perfect fit and strong enough to hang my fluke without worries.

How did I ever use my DVOM without it . Strong magnet hold the meter were you need it

This hanger fits great in my Fluke meter, is easy to install and value for money. Looks durable and safe for using, I also glued a circular magnet and its grip now is very strong. Thank you!

This works, but it is not quite the same as the original strap that comes with the meter I have. It is also cheaper than the name brand, and it does what is required. The magnet seems to be comparable to the original and supports the meter for any normal application. Note that some meters have the slot on the back of the case and other, very similar meters do not, so you might want to check your meter and set your expectations accordingly.

Magnet is strong, it holds a chunky Habotest/Kaiweets HT208D on a 3/8 " dia. screwdriver- even better on actual flat surfaces! Magnet is in a flexible rubber holder. Caution- width of strap is 0.98" (in description and as measured). This was too wide for my meter slot, so I used a 0.79" strap that I had. The orginal strap could also have been cut thiner. $11 seems like a lot, but the product quality is inline with the value of meters that depend on it.

Thought I'd be smart and 3d print one of these magnets because Fluke's are *way* to expensive for what it is. Problem is that 3D prints slide, even with plastidip sprayed on them. Figure getting ones of these couldn't be worse than my attempt. And was pleasantly surprised - it worked, and it held my heaviest meter. The rubber coating on the magnet held w/o slipping. I did print the part that slips into the slot on the meter, so I didn't need that part. This would be good for someone that wants to replace what they have or already have the part that slides into the meter shroud.

This is a good magnetic strap and is a very useful accessory for a multimeter. I bought this to use with my Extech 355 full sized multimeter weighing 0.82 lbs. The strap holds this meter very securely - no sliding of the meter down the wall. Users should remember that magnets work best on plain steel and iron. Stainless steel is much less magnetic (depending on specific alloy) and may not hold as well on those surfaces. I am pleased with this purchase and would buy it again, if needed for another multimeter.

方便好用

Der Magnet ist viel zu schwach um ein Multimeter aufzuhängen. Finger weg. The magnet is far too weak for its intended purpose, hands off.

see headline

Llego antes de lo que decia amazon y tiene buen agarre a las zonas metalicas no se cae con el peso del amperímetro ,ya habia comprado uno chino se caia con el peso excelente producto

Juste parfais! Bonne achat comparé au autre vendu par fluke