Aircraft Ultra Paint Remover - Powerful Formula Strips Automotive & Metal Coatings, Visible Lifting, Fast-Acting - 1 Quart

This stuff is no joke definitely wear a mask using this. Within a couple minutes you see the paint blistering and then hit with pressure washer and it’s all gone!

If you need to remove a really tough coating, this is the stuff you want! I restore antique sewing machines, and when I say restore, I mean taking every piece out of the casting and off of it, completely stripping and cleaning everything before disassembly. I work on all kinds antique and vintage models, but one very problematic one, as far as removing paint is the Singer Model 221 (Featherweight). Some people swear that the paint is somehow welded on to the casting, and I can tell you that it sure seems like it. That stuff it tough! It's no match for this stripper though. It'll take it right off. Now let's talk safety! PLEASE wear a respirator when using this stuff. It is STRONG. It'll make lacquer thinner smell like bottled water. It'll also burn you if you get it on your skin, so wear nitrile gloves! I don't want to see anyone getting hurt out there. As with any paint stripper, make SURE you get every bit off the surface and out of the crevices before you try and recoat. If not you'll be wishing you had. If possible, soak whatever it is you're stripping in a solution that will neutralize this stuff to avoid any problems with future paint lifting. Best of luck, folks! Be safe out there!

This product quickly and aggressively removes multiple layers of paint off a metal surface then look. I had previously used a different Klean paint stripper and it was taking forever to get the paint to bubble up. This one gets it done and quickly. I cannot say how well it works on wood, but for metal look no further, grab this product. **DO NOT use this in an enclosed area. This needs to be outside or well ventilated area.

I used this to remove paint from a cheap safe I was reinforcing and it worked good. I didn’t realize that how thick you have to glob it on there so it can go quickly for as expensive as it is compared to others. I would also warn anyways using this how strong the smell is and vapors are and how toxic it is to get on your skin. This IS NOT for inside. Even a well ventilated garage would be hard to use this in without breathing in these terrible vapors. Where I put it on thick though, it worked exactly as it said. It’s overpriced though IMO for as much as you have to use to work fully with the added smell and how quickly it will start to burn your skin if a glove rips while using. This isn’t something I would buy again though with as many other options there is.

Works very good. Poured it on and brushed it fairly thick. Covered with plastic and waited about an hour. Took the paint off of an Ingersoll Rand 120-gallon compressor tank that I'm turning into a horizontal offset smoke. A few spots were stubborn, but I probably spread it too thin. Ventilate well and make sure you use a good respirator, because the fumes are NASTY!

Pretty good stripper! Twice as good as the new crap the Green Care Act forced on us. Stripping sucks but this product makes it better! Also make sure you ventilate! It’s smells pretty bad

This stuff worked great on cleaning old powder coat off of an aluminum table saw top.

Bought this to strip five layers of world war 2 paint off a M29 weasel. Put it on thick and layered plastic sheet over it to slow the drying process. After 30 minutes I pulled plastic off and the 1st two layers came off with the plastic. Had to do this several more times but it worked. It was easy to use but make sure to use protective gear. This product is not cheap but worth the money.