WiltonLow-Profile Drill Press Vise, 6" Jaw Width, 6" Jaw Opening, 2" Jaw Depth (Model LP6)

Wilton has a reputation on making a quality product and this was no exception. Nice sturdy product at a respectable price.

Heavy duty, well built vise.

Accurate clamp throughout entire vise. Smooth action of screw. Worth the money!

I bought this vise to hold some <6" parts to drill fixturing holes before machining. Previously, I had to clamp the parts and carefully move them around to do this. Now, I just clamp in the vise and then either hold the vise (it's fairly heavy) or clamp the vise with much less effort than clamping the part. The jaws and ways are nicely ground, much better than a cheap drill press vise. A nice quality vise for this purpose!

This vise actually exceeds my expectations. It has nice mass, operates smoothly, came undamaged, the jaws are parallel, and they close as close to perfect as I can tell. It's a little larger in footprint than I was hoping for, occupying most of the table for my Rikon drill press, but in this case, better too much than too little. Can't go wrong.

Solid piece, plenty of heft for the money. Like anything that originates in China, needs to be field stripped and have the burrs knocked down, threads chased (8mm x 1.25) and countersunk, and flat sides stoned before it's ready to be put into service. Once that's done it's a beaut :)

I bought this for gunsmithing purposes and it has served me well so far. The only thing I would highly recommend is that you GREASE THE MAIN SCREW THOROUGHLY before use. My vice arrived with a thin coat of protective oil from the factory - as will yours. So you must grease - I used a basic moly grease - the screw before you use it.Also, check the screw head bearing (the part that connects the screw to the moving part of the vice) for fit. Mine was over-tightened and the vice was consequently difficult to open/close. Use a hex bit to adjust the grub screw at the head of the moving part of the vice (on top) to a degree that allows the screw to operate easily.

I purchased this to use on my vintage craftsman table top drill press and this vise is just way too big. I sent it back and purchased a smaller model. It pained me to send it back but it was simply too heavy and too large.

Bought an Amazon warehouse deal and arrived with a bolt slot snapped off. The box was damaged on the same corner as the vise. It said Amazon inspected condition OK . The vise itself is working fine and of good quality. just can’t bolt it properly. The price was lower but was expecting maybe few dents and scratches but no broken parts. Would have paid less for that kind of damage.