ID-COOLING SE-903-XT-BLACK Small Side Flow CPU Cooler for Intel & AMD with 3 Heat Pipes

Wonderful cooler. Honestly. I didn’t not think it would perform well but I put it on my Ryzen 3 2200g cpu without thermal paste as I needed to run some tests and was surprised it kept it cool at a nice 60 degrees Celsius. Fan was quiet too. Zero compaints.

Micro-ATXケースで高さ制限があるので、全高120mm前後のクーラーを探していました。Ryzen 5 5600Gに使用しましたが、すっぽん防止ブラケットが付けられるコンパクトなクーラーは、現状これい一択かもしれません。取付け自体は、それほど難しくはありませんが、ヒートシンクをマザーボードに取付け、最後にファンをスプリングで取り付けるのが、結構難儀でした。ゲームもやらず、マザーボードがA520でオーバークロックをしませんので、冷却に関しては全く問題ありません。

This was my first time installing this kind of Cooler. It is a little more annoying than the kind that doesnt need you remove your motherboard to install the back plate but its worth it, and probably less annoying when building a new PC. But Anyways just pay attention to the instructions included, and make sure you install the brackets with the screws in the centers upwards, as this is what the radiator will attach to. And dont over tighten it. Just until it stops wiggling. My CPU was running IDLE at 60 degrees Celsius, and now runs much cooler at 40 Degrees Celsius. Even under it load doesnt get much hotter. I did make upgrades to my system, as it was a gift. I guess the new ram sticks, as they are technically mis-match, made my CPU run a little hotter despite a 12GB upgrade. The cool thing is that I can bring this to my next build if I want, but I most likely will just order another one since its pretty affordable. I definitely recommend this, I cant attest to overclocking or anything like that. But it fits what seems like every socket type, although I saw no mention of AM5 socket but if you know if AM4 and AM5 are similar in terms of screw placements, then this may not be bad, but if youre running DDR5 then you probably can afford a better cooler even water cooling anyways. This is my very first PC experience and honestly everything is idiot proof lol. My grandma probably could install this.

I installed this cooler on a Ryzen 5 3600. Installation was easy, the included instructions are clear enough, I just wish they labeled the screws and the standoffs better since I spent longer than I thought I would on figuring out which ones to use. Also, the included thermal paste comes in a little sachet, and there is barely enough for one installation so if you get it wrong, you won't have more to re-apply. With this cooler, the CPU idles at around 34 degrees and when under load, it stays at around 75 degrees. I'm genuinely impressed by how good this little cooler is. It only has a 92mm fan and 3 heat pipes, yet it's able to keep the temps under control. Overall, I'm genuinely impressed by this cooler.

I replaced the stock cooler on my Dell Optiplex 7080 (i7-10700 CPU). Perfect fit, I was able to use the existing Dell backplate and did not have to remove the motherboard. This Dell PC uses a standard 4 pin CPU fan connection, and there was no BIOS warning going from the stock 80mm fan to the included 92mm fan. I saw a 25 degree drop in temps at load, although the old thermal paste was pretty crusty. Easily fits the mid tower case and clears the RAM. The PC is much quieter now that the CPU fan isn't constantly ramping up and down. An excellent upgrade.