TOOLSCENTRE Proxxon 37080 Hot Wire Cutter THERMOCUT

This thing is great for foam model making, cuts like butter. I will say the fence would use some modification to keep it stationary and square.

It pays to read the specifications thoroughly before going through with a purchase. Had i done so, i would have seen that this is a 110V powered machine and not 240V. That's important for me in the UK as i had to then buy a step down transformer so i could use it. Now that i have the transformer i have to say i am mightily impressed with the cutter and the possibilities for me are endless with it's multiple uses and angles that it can cut. It cuts through the XPS foam effortlessly with clean crisp edges. I even tried a thickness of 1mm as a test, and it cut it without any problem. I only gave 4 stars because it advertised the cost in British pounds, but at the same time did not make it clear on the initial product information page that a step down transformer would be needed for use in the UK.

Tenia una falla que hacía que no pasará la corriente al alambre y no calentará, al intentar hacer la devolución me mandaron una etiqueta que no era la correcta para DHL y enviarlo por mi cuenta costaba 2 mil pesos, afortunadamente es sencilla de reparar

This little unit makes building tabletop gaming pieces so much easier. The couple of steps to assemble it was a little tricky for me (I don’t have a lot of previous experience with this sort of thing) but I figured it out in the end. The only downside is the fence needs upgrading if you plan on doing wide cuts but other than that it’s an amazing tool.

Es un poco difícil de calibrar, los tutoriales no son del todo útiles, creo que sería mejor comprar una más barata que te ofrecen casi lo mismo