3D Printer Glass Bed Borosilicate Glass Buildplate w/Corners Cut 130x160x3mm for Select Mini V2/ V1/ Pro/V3/ Malyan M200 with 2 Glass Clips

This glass is the upgrade of the default surface of the printer work bed. The adhesion was unreliable and many prints failed because of that. With the glass it is much better. Fails sometimes, but if to clean the glass with alcohol before printing, works good for me.

Fits perfect and works as described. Had so much trouble printing on the default buildtak, ordered this and everything became much easier. Also, prints have a much, much nicer bottom on a glass bed!

This is exactly right size, and the corner cutouts are clean and in the right spot. I used high temp tape to secure it to my bed, which wasn’t the best idea as the bed will bend and warp while the glass doesn’t—I know that’s the idea, but it doesn’t make leveling easier.Be sure to print off a z-axis spacer before installing. I’d recommend binder clips over what I did. The actual glass is great though!

Overall, this glass works well, but after only a few uses, I noticed issues with adhesion and had to reglue. Also, the corners are cut way too deep for accessing the bed leveling screws. Therefore, I've had to significantly shift the glass so that the prints dont fail because they run off the glass edge. I have about a 3mm overhang of glass on one side of the print bed due to the shift.

The binder clips are a little low-rent but this glass bed will greatly improve your print quality. Your flat surfaces will be as smooth as glass. I recommend using Aqua Net hair spray as an adhesive agent with it.

No more constant leveling and fighting with the bed to get your prints. This glass bed makes it super easy to level your bed and when you're done printing, the prints pop right off unlike the stock bed. Just make sure to use some glue stick so your prints will stick to the glass!

Not worth the money

Not much to say. It fit fine and works well. It's just a piece of glass, but using it and glue sticks has temporarily fixed the problem with the heated bed not working. It sticks well enough this way that I can get by until I get around to fixing the wiring on the heated bed. I might not even bother fixing the bed...again.