EUICAE Adjustable Wrench Clutch, Stainless Steel, 11.8in Length, Suitable for Different Distances and Sizes

This tool is amazing! I fought the fan clutch pulley on a 1996 C1500 for 2 days in 110 degree heat this Summer trying to remove and replace the clutch and fan blades. I finally gave up and started looking for a tool to do what this does but everything I could find was more than the clutch assembly and fan blades combined and then some. Even the tool rental at the auto place up the road was damn-near $100. I found this tool, ordered it, and within 5 minutes of pulling it out of the box I had the fan clutch and blade pulled out and in the driveway. I've paid a lot more for tools that don't work a quarter as well as this one did. Even though this might only have one specific use, it does it well and did in 3 minutes what I hadn't been able to do in 6 hours. *The pins are larger diameter than the holes on the pully but I removed 2 of the 4 bolts holding the pulley to the water pump and used those as my leverage. If you run into the same problem you may find that the same solution works for you as well

Great Product at a Great Price!

It got the job done I ordered it for, getting a nut off a lawn tractor blade spindle pulley. The only issue with it is that the lugs that engage the holes on the pulley are the same length and an the offset is built in by the fact that one lever is on top of the other. If they had used different pins, one longer and one normal, it would have been so much better. But I suppose for $10 it worked, you just have to hold it in place more that you would have or it might slip off.

A little combersom using this to remove the clutch fan from my 4.7L Dodge V8 but I eventually got it in to hold the pulley. The larger pegs on the opposite side of the arms are what made the clearance tight but otherwise once it was in it was cake. The tool is very sturdy and seems to at least be able to easily take 95 ft/lbs of torque without any issues.

Very well made. I used it on the circular nut on a bulkhead fitting on a large 2500ga potable water tank. Was able to easily tighten the nut. Could not do it with any kind of strap wrench.

Did not work for a Honda reflex

I bought this for adjusting an automotive carrier bearing set and it works perfectly for that. It has a nice feel and weight to it. The tips are threaded so you can remove them and use both sizes. I used the smaller tip side and was pleasantly surprised. Priced right and works great!

This thing is the worst of the worst. It snapped in half first time. I even tried to put any type of pressure on. It probably couldn’t even turn a door knob without breaking. Do not buy!!!! absolute garbage!!!

Works perfectly on a PGO GMax 220i.

Work great on my 06 Dodge Durango 4.7 water pump pully. love the long handle that give u great leverage for a one man job. Everything on the tool worked great not sure how anyone could give a bad review. GREAT TOOK AT AN AMAZING PRICE A++++

Terrible craft, not worth the price. Looks bodged together from scrap metal.

It needed to open up a bit wider to fit as intended on the primary clutch of my ATV, but it work in any case by grabbing the cooling fin rather than the intended clutch location. It saved the day!

Worked for my 2010 Dodge Ram Cummins. Thin metal, not to strong.