AVF ZA180W-A Low Profile Cable Management, 6 Foot Length

This worked great. We did follow the directions to unroll and let it rest so it wouldn't keep curling up. We also needed to add some screws to the application as the tape was not sufficient on our textured walls.

Did the trick. We mounted our TV to the wall and of course needed to hide the cable. Another buyer was disappointed with how curled up it is, and is difficult to keep flat.After unboxing, I immediately feared it would be the case. However, after cutting to the proper length (just needed about 8 inches off, which was doable with heavier duty household scissors) I was able to adhere to the spot where I needed it.After peeling the 3M tape I used the soft side of my fist to run up and down the sticky sides. After a minute of doing so it had a very solid contact with the wall.A side note, have velcro straps or zipties. May be common sense, but it would be far too frustrating to deal with the separated wires and cables.I ran the bundled cables against the bottom layer, and the outer layer clicked in with relative ease.In the end, it looked much better and cleaner. The best part, the outer layer was simple to remove and replace when adding cables.

I used this product on a flat screen installation where it meshed well with the client's decor. The run was also 70" so the 6' length was ideal (Many products are 60 inches and would have required a splice).I knew it would come rolled up bu I wasn't worried, I knew that some steam and a heat gun would flatten the coil... uh right.The tape is a joke, I never deluded myself that it would be strong enough, but I didn't mind alternating screws down the sides.I got both pieces nice and flat to go on the wall.HERE is the issue: The back was flat and straight, BUT the cover was NOT straight and curved slightly to the left as viewed from the top end. So, when you try to interlock the edges the outside of the curve, in this case the left edge as I faced it would not go into or if it did, would not stay in the track. I finally had to brute force it into place and screw it down... Now new cables cannot be added without removing the screws to free the cover.This is a HORRIBLE product! A good idea but a VERY poor execution.

I like it. It was a little wonky to install but it works and is good once you get it in. The adhesive on mine was a bit sub par & kept falling off. Possibly because I was putting it on a wall with high gloss paint. I ended up using a few strips of 3M double sided tape and three nails just to make sure it stayed up. Bending the cover was a little tricky to get started but once you get it started the rest goes in pretty easy. All in all a good buy for the money. I did not paint it but the manual says it's paint-able.

I absolutely can't believe this fabulous item is receiving low reviews with people citing that they couldn't straighten or install it. I installed it quickly and easily, no problems at all. It does come rolled tightly but you just need to use the flattening technique described in the instructions (holding it between your legs and pressing it in the opposite direction section by section with your hands. I was able to straighten mine out within a few minutes of doing this. It attached right to the wall without any hassles and looks great!! See photo! If you're considering buying this, do it! Just follow the directions and it's a breeze to install. I had several cords coming from my TV to my speakers, Roku device etc, it looked horrendous and now it FABULOUS!! Yay!

I use this for a TV I have mounted to the wall on a swivel arm.Works as needed. However, the round plastic cover is constantly coming off when moving the TV around, and the adhesive for the backplate is pointless. I ended up having to screw the backplate into the wall so it would stop popping off. Not much I can do about the cover coming off except to keep my cables a little longer so I have some slack.Bought for $18 - $20 I think some time ago. Might be more willing to pay for this again if it were half the price due to its performance.

Very straight forward installation. Take it out of the box, roll it up the opposite direction, let it sit for about 30 to 35 minutes, take it out, trim, level, stick. Only took about 2 minutes to get everything where it needed to be.Very clean look once painted to match your walls.

Easy enough to install, if you follow the directions (unlike half the 1 star reviews). My only complaint is that I was sent an obviously returned one. It was already cut, crookedly, the tape had already peeled off (thank goodness it was the piece I didn't need) and the piece I DID need has a black mark smack in the center of the part everyone sees that I couldn't get to come off. All in all, you get what you pay for. It looks better than a wad of cables. If it ends up not staying in place I'll edit this, but probably still keep it and just buy some other sort of adhesive from Lowe's. Yay for owning and renting.

El diseño es agradable sobre todo si se busca evitar las "clasicas canaletas" cuadradas que tal vez no se sean muy bien en algunos lugares, es muy fácil de instalar y la gran ventaja es que para poner y quitar cables se puede montar y desmontar la parte de arriba sin ningún problema, buena calidad y buen precio.

Hides the corded beautifully and is easy to assemvle

Funciona bastante fácil de instalar y el hecho de que lo puedas cortar con tijeras es un plus enorme, sin embargo, es mucho más grande de lo que se ve en las fotos, y el adhesivo no es resistente en lo absoluto

It’s hard to roll straight and don’t stick to the wall.

Save your money