Vevor Sandblaster, Professional Lab Sandblaster with 2 Pens & 2 Tanks, Dental Sandblasting Equipment with Led and Glass Window for Surface Treatment of Materials

Im loving this thing! I use it for jewelry and it works great. Very fine pointed spray, perfect for delicate jewelry work. Gets into the little crevices to remove casting oxidation etc, that can be difficult to reach with my rotary tools. It does leave a light sandblasted finish, (Obviously) but I put my pieces in a tumbler with steel shot and it comes out perfect. Ive used this on silver, brass, bronze and copper. You do need an air compressor to connect to it, and I have a small shop vac that attaches to the back to keep my shop clean from the vent on the back.

This Item was as described, Packaged properly and shipped promptly. Functioned as expected. With proper tube ventilation on vent tube the dust produced is not as bad as I've seen it described in other reviews. Instructions for use are a bit confusing but overall easy to figure out.

This little sandblaster has no dust collection, so you'll need to add a filtered hose or collection box to the back or it'll cover your workstation with sand within seconds. Emptying/reusing spent media is kind of a pain, but the whole box is so small and lightweight that you can just pick it up and dump everything out to re-collect it. You absolutely need to invest in some replaceable screen protectors so you don't etch the window and lose visibility. The only thing the power cable powers is the light. The foot pedal is just an analog air valve, not a solenoid, so when you release the pedal, media continues blowing for a couple of seconds. If that isn't a dealbreaker for you, this system is absolutely worth it. Paid for itself with one project.

The used media is not recaptured, instead it literally just blows out a hole in the back and makes a mess. I had to engineer my own solution for that. Other than that it works great.

Amazing blaster. Highly recommend it

Does not work it makes so much mess. wanted to send it back but lost packaging.

I make a mask with a cricut cutter, apply to a rock or glass, and this sand blaster is easy to control and gives a nice deep engrave even on agates on those small letters. Note that it is a very fine tool, perfect for fine engraving but not what you want for cleaning big tools. You need your own air compressor, and will probably have to put together a couple of connectors from the hardware store to connect the compressor to the hose. After that, it worked great right away. Also, the mess in minimal. There's a hole in back I could connect to a dust catcher but I use it outside and it doesn't produce much dust (I still wear a mask and goggles!).

Amazing, only have to read very well the instructions and then have a good air pressure and the machine works perfectly