classAcustoms 35ft TPO RV Rubber Roof Kit | 8.5' Wide | Camper Rubber Roof Kit

My husband had to install a new membrane on my moms rv. At first we thought it was be a challenge but the installation was alot easier then we thought. My husband had no issues installing it and now my mom is very happy with the ending result.

Not enough adhesive. Nowhere near enough tape. No instructions, tips or hints for a proper installation. Send a question to the supplier, but no response. Thinking about spending a few hours with customer service to feel like I got my money’s worth.

Great value for the money. Don’t let the adhesive get sticky otherwise you get creases/air bubbles that are difficult to get out. Went on super nicely but it still had folds even after laying out for 2-3 days before applying.

Has everything you need plus extra for replacement of your RV roof. Took me two days to complete.

It was my first time over putting one on so it was pretty difficult. But it all worked out okay the next one will be a lot simpler. Just need to make sure the surface that you're going to is really slick and flat and you will have no problems

I used my smallest trowel 1/8 pointed notches but came up half a gallon short of glue. Plan on about $57 for an extra gallon.Roofing comes folded in a box. It has to be converted to a roll like rolled up carpet. This is a job for on the ground. Plan on sweeping it clean as your roll it up.There may be a need for a better youtube for this stuff. The ones I found didn't have enough tips like get a foam mat for your knees. This job is very hard on the knees.I would buy this product again. I should have done it sooner. Damage didn't show much inside but once I got into it water had gotten under the old roof and did damage. I eliminated many bad spots like the luggage rack. Who puts luggage on the roof of a 35' RV? Put your luggage inside. Roof over all those screw holes.

Upon receiving the folded material, I unfolded it as directed. I noticed that the material was curved along the long-run length on both sides, convex (RH) and concave (LH) on opposing sides. When I rolled this out on the roof and forced the concave curved (LH) edge to meet the riveting line, the convex edge (RH) lifted from the roof surface by 10" and would not flatten out, no matter how much pulling and repositioning I did. When I brought this to the attention of Class A Customs, their responding person blamed the curvature of the roof and denied any assistance. Beware of customer service from this supplier.

The product is as it was expected and good quality. The packaging was HORRIBLE. They folded the TPO material and placed it into a box. The material had folded and creases in it. Making it terribly difficult to lay flat had to use a low heat gun and silicone roller to work the folds and creases out of the length of the TPO. The TPO material should have been rolled on a cardboard tube and shipped not folded. Very disappointed in the condition of the tpo when I began installing it. But will make due.