Upgraded Lifetime Appliance DC64-00802B Door Gasket Boot Seal Diaphragm Compatible with Samsung Washer

This washer door gasket seal appears to be much more durable than the original and I expect it to last.Installation wasn’t all that difficult but I would recommend watching videos online of washers that most closely match the one you are replacing.

Went right in and everything lined up, including the inlet valve and drain

Stopped the leaking. Guys, it works. Save me a few hundred in a new washer.

The original gasket on my WF220ANW was ripped in two places, causing less than half a liter of water to spill out the bottom. My wife was chill about the leak because it evaporated daily. However, I am having the floor retiled (er, revinyled), so the leak had to be gone.The YouTube videos are helpful, but my unit had the brick weights on the top and bottom (an older configuration, perhaps?), not on the sides as shown in all the videos. This configuration made the rear wire completely inaccessible. So, I had to disassemble more than expected. I did remove the door, which let me wire brush the rust spots and repaint the bottom of the inside of the door.The best advice I can give on the gasket reinstall: concentrate only on getting the outer material on the lip/flange. If you much about trying to stuff the gasket material into the gaps, it will seem as if the replacement is too big. Oh - and be careful to get the detergent filler shelf into the control panel correctly (flush, so it does not leak). Hard to describe, but you can see it if it's off kilter. I'm a dummy for not taking photos but hope this helps anyhow.This replacement part seems like great material, great price, and it did the trick on my ~10-year-old unit. Took me at least 3 hours.

This seal fixed my washer right up! The process took quite some time but it was worth it and saved us money. The shipping did take longer than expected

The original on my Samsung was getting moldy and dirty, found this on Amazon, followed YouTube videos and had it swapped out in no time

Got the product on time and works perfectly fine.

The videos out there are for other than than "210" model. I'd recommend taking notes and/or photos during disassembly and removal for reference during reinstall. The counterweights are a bit difficult to work around and gloves were not handy for me to assure the "ridge was in the groove" so I used plastic automobile trim tools to assist. I also could only use a 7mm open end wrench to remove the inner clamp. Once you guarantee easy work access and lighting including a flashlight, have your tools available and a kneeling pad I'd plan 90 minutes. IDK how anyone says you can complete this without front panel removal.

I was not sure if it is same size of my old one. Attached picture shows my washer's model. It is exactly same as the original one. It was not easy to install, even I watched the YouTube video. But after two hours with help from my wife. It was installed successfully. My wife said it looks like a new washer.

The product was exactly what we needed. Install took about 45 minutes and was very easy to do.

Gasket fit perfectlyI paid $90 but the import papers says the value was $15, cheaper then a new machine but still is overpriced.

Remplacer l’ancien .

Fit perfectly!!! I fixed it myself. Watched a tutorial and it really helped. And very affordable price on Amazon!!!!