DNA MOTORING17 Gallons Aluminum Top-Feed Fuel Cell Gas Tank 29.5" (L) x 7" (W) x 17" (H),ALU-FT-B-TF-17G-T2-BK

Installed in the trunk of an old car to eliminate the rusty original tank. Had to use a small inspection mirror to determine the fitting porting. Put a sheet of 1/8" rubber under the tank and a strip under the hold down bracket. So far so good.

This a very shiny and nicely made fuel cell. I’m giving one star because the stated the tank included anti-slosh foam which is a lie. I paid more from supplier because the foam was said to be present which it is not. Buy from another supplier. This one cannot be trusted.

Didn't need the polished finish but it grew on me. I would advise customers who purchase any fuel cell to clean it properly prior to use. Mine has polishing debris balled up in the bottom of the tank and would have easily clogged a filter. Other than that it was packaged ok (without tech data sheet or instructions) and it suited my project perfectly. Was amazed that I had it less than 24 hours after I placed the order.

Overall the tank was good quality. It does have desing flaws though The sending unit leaks and the bolts around tbe fill cap the threaded holes where the sending unit mount go clear through the tank as well as the filler plate. They did not seal ANY bolt penetrations anywhere. They all leak !! Its leaks badly around the bolts when the tank is full. If you remove the sending unit to seal it up, a clamping ring inside of the tank will fall inside ! Be careful, Virtually impossible to reinstall.

Very light, hope it stays good. Thin metal. Lots of bad reviews, lots of good ones. Time will tell.

First off I just want to say that this tank is very shiny and looks great but, that's not why most people buy a fuel tank. Besides unless your laying under the car your not gonna see that shiny sh*t.I bought this tank for its size and its capacity 17 gals. Well I could barely get 15 gals in it.Oh yea, you better be prepared to clean the crap out of the inside before you install it....ITS NASTY.I pressure test it prior to install.......alot easier to weld up any holes before you put fuel in it...........NUFF SAID........

I used this on a hydrostream boat rebuild. It's been in the boat now for about a year and is going strong. Haven't measured actual capacity, but it does what I need.Update: 2 years and it just started leaking at a lower weld. Pulled out to repair. Still no real complaints. Holds about 16.5 US gallons

Bought this tank for my pontoon. Works great. 12 gallons in 1 tank. Don’t need 2nd tank to be safe. If I find I do I’ll buy another one like this.