VINYL FROG Heat Transfer Vinyl PU HTV Vinyl Bundle 35 Pack 12" x 10" Iron on Vinyl Sheets for DIY T-Shirt, Clothes, Hats and Other Textiles

This has got to be the best vinyl I’ve worked with so far. Easy to weed and cut. Did find it a little difficult to see the cut but my eyesight is pretty bad. Overall won’t buy anything else. Thanks

Honestly this Vinyl is amazing! It’s extremely easy to weed and so easy to remove the backing once pressed. I will 100% buy more, and as you can see this adhered so well to sash material!

Great product easy to use great bright colour

New review for chameleon green to purple: I wish they could let you review the individual items from the same listing, as I have an older review below this one for a different style.Anyway, I bought the chameleon because it was close to a chameleon style I've used from another brand. I love it, 5 stars from me for this vinyl. See the photos for the beautiful effects. It cuts on my cricut really well (although if you use masking tape to secure your htv to the cutting mat do be careful removing it, the htv surface is a little weak and if you pick and pull at the tape you will damage the vinyl. I suggest making sure the tape doesn't overlap any of your design so you don't have to pick it off)It weeds very well, too, nice and easy to pull the excess away. And it presses perfectly. I always give an extra second or two on the recommended settings, and then after I've pulled the carrier sheet off I give it another press for about 5 seconds.I've used it on 100% cotton t-shirts and I LOVE how it looks. Can't recommend enough.--Red HTV: I ran out of my red HTV so I tried this one. It's a really nice rich red, not garishly bright red at all. Perfect colour for me.It's actually a lovely feel vinyl, feels like it will survive stretching on clothing, however I've only used it for zipper pouches on canvas.I've knocked off one star only because I find it's very easy to warp this. I went by the instructions on the product packaging, and I got some shrinkage on the corners of my pentacle (see photos). I was very careful a third time but the vinyl didn't adhere properly so I had to go back over it, again, very carefully. I'm using a mini hand heat press, so I have to do these in sections. I make sure there's little or no overlap and there definitely wasn't for these corners, so forewarning to people with a mini press, be strict with the seconds needed with the heat.I was on my lowest heat setting too so I couldn't go lower.Overall though, I'm really pleased with how it looks. There's not as much glue reveal as the other vinyls I've used (always a plus, I don't like how you can sometimes see the glue residue around your design), and it's a really nice matt finish.

Really nice vinyl nice to work with.

Really good product. Would recommend

Nice enough stuff, cuts reasonably easily, weeds OK - but. Try feeding it via a roll feeder and it curls at the end, jams itself into the slot and throws the job into complete disarray. Option 1 is feed more through first and waste it; option 2 is stick it to a mat, which defeats the point of buying it on a roll.Might be down to too thick a carrier sheet, I'm not sure - but there are other vinyls out there which do not suffer from the same degree of curl.

Love this product easy to work with and look effective