6pack Microphone Shock Mount Spacer Rubber Tube Washer Compatible with Sony Camcorder Rode NTG, Sennheiser MKH418 MKH416 MKE600 FX3,FS7,FX6,FX8,FX9,NX80,FS5 and Shotgun Microphone

Works great!! I had to wrap the cam mic with a few wraps of camera tape to get it to fit my mic mount and that did the trick.

If you have a smaller diameter mic like a RODE NTG-3, you'll have to double stack the spacers. To do this properly, grab some scissors and cut off the trim ends on one spacer, then wrap it around another spacer. This results in a perfect fit for those skinnier mics. This lets me use my favorite shotgun mic on my cam and that's good enough for me!

Excelente material

They advertise this works for the 416 and the FX3 handle but they are too small on the 416.

I love my Sony FX3, but the diameter/sizing of the built-in mic holder has always been a hassle. I'd seen the expensive, bespoke spacers that were available online originally, but I'm cheap so for years I've just been using a strip of rubber lattice cabinet door padding, cut to size into a strip and wrapped around the mic before clipping it into the audio handle.This works fine and is very cost-effective, but is a hassle as my "solution" had a tendency to not stay in place on the mic and make setting up my camera more of a hassle.So, getting six of these bad boys for around $2 each is a definite upgrade. It fits like a charm on my Audio Technica shotgun mic, does a better job of holding the mic in place, and performs the same function as both spacer and to reduce handling noise. And if I happen to lose one, I have five more.In my opinion this is a must have for any FX3 owner, and the dang camera should have shipped with something like this in the first place.

Pretty simple, but necessary accessory. I'm not using it with a Sony camera, but it works fine with the camcorder I have. I had to cut down the diameter by 1/4" for it to fit, so you know this can be used with other brand cameras as well as Sony. I like the 6-pack too, as I have already lost one of the rubber mounts because I wasn't careful in putting the camera away one time. Lesson learned.The rubber is nice and flexible, not sticky, and just the right thickness to securely hold the mic in place in the camera mount.